This is a universal RAM holder that is designed to hold a large number of phones and other electronic devices (see dimensions below). It comes with three sets of four flexible rubber coated fingers to grip your device.

The fingers open by squeezing the ends, to open the small finger arms. This holder will then also connect to the RAM Mounts system, allowing you to mount your phone almost anywhere.

This mount is designed to hold the following devices:

• Mobile Phones (check measurements below for dimensions)
• 2-Way Radios
• GPS Devices
• Works with OtterBox (Defender, Commuter, Impact) Cases, Phones with Bumper, Twisted Metal Case and More
• Perfect rugged solution for the Blackberry, HTC Evo, Droid X, iPhone, and More
• Use on your Motorcycle, ATV, UTV, Car, Boat and More 

Height Dimensions:

• Minimum with Top and Bottom Plates: 5.25" (13.34cm)
• Maximum with Top and Bottom Plates: 6.0" (15.24cm)
• The top and bottom plates can be removed for larger devices.

Spine Plate Dimensions: 

2.5" Width x 5" Height (6.35cm x 12.7cm)

Using Short Arm Side Clamps:

• Maximum Depth: 0.75" (1.90cm)
• Minimum Width: 1.25" (3.18cm)
• Maximum Width: 3.0" (7.62cm)

Using Medium Arm Side Clamps:

• Maximum Depth: 1.25" (3.18cm)
• Minimum Width: 1.5" (3.81cm)
• Maximum Width: 3.5" (8.89cm)

Using Long Arm Side Clamps:

• Maximum Depth: 1.5" (3.81cm)
• Minimum Width: 2.25" (5.71cm)
• Maximum Width: 3.5" (8.89cm)

Features:

• Material: High Strength Composite
• Made in the USA and comes with a lifetime warranty

Note:The "U" in the part number reflects product packaged in poly bag. RAM holders do not include the RAM-B-238U (Diamond Base & Ball) or RAP-B-238U (Diamond Composite Base & Ball), required to attach to the holder and RAM mounting system.

Availability:

RAM Mounts supply is pretty good in Australia, but they have thousands of parts so we can't stock them all on our shelves. If our site shows this item as in stock in our warehouse (see above), great! It will ship immediately from our warehouse. If it shows as Pre-Order, we get fortnightly shipments from RAM Mounts and our site should show if it's in stock in Australia.

• If in stock in Australia we can have it in about a week or less
• If it's not in stock in Australia, unfortunately the ETA can be quite long, as RAM Mounts in the USA have a manufacturing lead time of 6-8 weeks. But if you'd like to contact us we can find out a more accurate ETA for you