RAM-B-309-1U :: RAM Motorcycle Brake/Clutch Reservoir Base with 1" BallSKU: RAM-B-309-1U
Rated 4/5 based on 4 reviews.
Make 4 interest-free payments of $6.24 fortnightly and receive your order now.In Stock : 3
This product will attach to your motorcycle handlebar brake/clutch clamp, and allow you to then attach a variety of electronic devices to your bike, using the RAM Mounts 1" ball system.
The base of this product fits the control clamps on your motorcycle with 40mm x 6mm stainless steel hardware (included). To see if this base will fit your motorcycle, check the hole spacing of the base against your clutch/brake reservoir. The holes centers have a minimum width of 0.94" (2.39cm) and a maximum of 1.58" (4.01cm).
- Material: Powder Coated Marine Grade Aluminium
- Ball Size: 1" Rubber Ball "B" Size
- Made in the USA and comes with a lifetime warranty
Note: The "U" in the part number reflects product packaged in poly bag.
|Country Of Manufacture||United States|
Very GoodBy: Jeffrey on 22 October 2018Very good and prompt service. Delivered as quick as they promised
Almost does the job perfectly14 August 2016The bracket is perfect but all the screws sent with it have too broad a thread for my Guzzi so I had to source alternate screws to fit it. I had previously had the same issue with a fitting that came with a GPS
Convenient and sturdyBy: Wan on 4 December 2014Attaching the mount was simple. Fit is perfect and easily adjustable. Helps to use a little blue thread locker but not necessary if you don't want to. I highly recommend getting this if you don't want to attach a mount to your handlebar. Personally, I don't have enough room on my handlebar to fit any more attachments so this is the perfect solution. I've attached my GoPro with a short extension arm. Vibration is minimal but that could be also due to my suspension settings.
Great way to fit you stuff to bikesBy: Rudi on 9 December 2013These Mounts are fantastic to mount both my GPSr and GoPro to my bike. No vibrations and easy to adjust